How to install t111

Hold a panel at the correct height and against a window or other obstruction to mark for the horizontal part s of a cutout. Measure over from the other panel to mark the top and bottom of the vertical cut and snap a line between the marks.

However, T should never actually be installed flush with the ground, as this contact can increase moisture buildup and promote mold growth. Repeat the process to install further sheets of T siding. You should always paint T siding with a good waterproof paint, as this is the only protection the siding will have from weather conditions.

Autumn Johnson has been a freelance writer for over 11 years. Determine the lap of the siding. If you are planning on installing T siding, then you should know about the tools, materials and techniques available for a successful installation project. T siding is untreated. The paint covering the siding is the only protection the siding has from moisture intrusion. Even the most T siding is a type of plywood siding that was once one of the most commonly used types of siding on homes, Install T siding by nailing the sheets of material to the framework of the house or structure.

Use corrosion-resistant nails to avoid Secure the sheet in the same way you secured the first one, leaving the opposite edge unfastened until you fit the next sheet over it. Measure the last sheet in the row to fit between the second-last sheet and the corner of the wall and cut it with a circular saw. The corner trim will cover it. Hang Z-flashing over the top of the row and nail it to the studs before installing another row on top over it.

The flashing protects the top edges of the sheets, which are the most vulnerable to water damage. Trim T with 1- by 3- or 4-inch lumber. Nail the trim to the corners of the house and around windows and doors with 8d galvanized finish nails. It is also common practice to trim the tops to the sheets, where the wall meets the soffit, and the bottoms, where it meets the foundation.

Paint or stain T after installing it to lengthen its lifetime and enhance its appearance. If you paint it, giving it a coat of exterior primer adds protection and increases paint adhesion and coverage. T should never be installed in contact with the ground. Ground contact introduces moisture that causes the plywood to separate and promotes mold. Chris Deziel has a bachelor's degree in physics and a master's degree in humanities. Besides having an abiding interest in popular science, Deziel has been active in the building and home design trades since